-Hold any number in for a little
-Put Battery back in
-Press Radio Learn 2 Times
-Type in 1,2,3,4
-Type in Code from remote: Look at switches inside of remote. Enter the numbers of the switches that are pushed down at the top, by the number, using 0 for 10.
-Press Radio Learn
-Type in 1,2,3,4 To test keypad (door should open or close at this point, if it does not, you either made a mistake in the above steps, or the keypad is not functioning properly)
-Wait about 30 Seconds (until lights stop flashing)
-Press the Access Learn button 2 Times -Type in 1,2,3,4
-Type in 4 digit personal code
-Press the Access Learn button