Multicode Keypad Reprogramming

  1. Take Battery out
  2. Hold any number in for a little 
  3. Put Battery back in 
  4. Press Radio Learn 2 Times
  5. Type in 1,2,3,4 
  6. Type in Code from remote: Look at switches inside of remote. Enter the numbers of the switches that are pushed down at the top, by the number, using 0 for 10. 
  7. Press Radio Learn
  8. Type in 1,2,3,4 To test keypad (door should open or close at this point, if it does not, you either made a mistake in the above steps, or the keypad is not functioning properly)
  9. Wait about 30 Seconds (until lights stop flashing) 
  10. Press the Access Learn button 2 Times -Type in 1,2,3,4
  11. Type in 4 digit personal code
  12. Press the Access Learn button